Carrier® 33CNTRAN485-01-R 1097027

The BACnet®/Modbus Carrier® Translator is a micro controller-based module that provides the ability to integrate Carrier® CCN-based controllers into Modbus and BACnet® networks. The BACnet®/Modbus Carrier® Translator (33CNTRAN485) provides CCN to Modbus Remote Terminal Unit (RTU) and BACnet® Master-Slave/Token-Passing (MS/TP) protocol conversion The Carrier® Translator can be mounted in the controls section of any CCN equipment and converts CCN-based controller data to BACnet® or Modbus. The Carrier® Translator is outdoor-duty rated and contains CCN RS-485 and BACnet®/Modbus communications connectors. When connected to a CCN controller, the BACnet®/Modbus Carrier® Translator allows a third party BACnet® or Modbus device to read and write to the CCN controller's mapped status display, time schedule and set point schedule data. Note that status display write access is subject to the CCN equipment controller's defined read/write access for each status display item.

Carrier® Modbus Translator, 5 in Width, 24 V Input

• Three-wire removable BACnet/Modbus connector
• Three-wire fixed screw terminal CCN connector
• Two-wire fixed screw terminal power connector
• Red processor status LED
• Yellow CCN communication status LED
• Green BACnet/Modbus communication status LED

• Instruction/Installation Manual https://assets.unilogcorp.com/267/ITEM/DOC/Carrier_33CNTRAN48501R_Instruction_Installation_Manual.pdf
• Specification Sheet https://assets.unilogcorp.com/267/ITEM/DOC/Carrier_33CNTRAN48501R_Specification_Sheet.pdf